Products

The 20 SWG Polyester Enameled Copper Winding Wire is a high-quality insulated copper wire designed for electrical winding and electromagnetic applications. Featuring a durable polyester enamel coating, this wire provides excellent electrical insulation while maintaining the superior conductivity of pure copper. With a length of 2 meters, it is ideal...

The 200 RPM DC Johnson Geared Motor 12V (Grade B) is a high-performance yet cost-effective solution for a variety of robotic and mechanical applications. This DC motor features a sturdy metal gearbox and an off-centered (side) shaft, designed to deliver optimal performance in tight spaces. Operating at 12V DC, this...

The drive shaft is equipped with a clutch for intermittent protection, safeguarding the gears against sudden overloads. This straight BO motor operates smoothly across a voltage range of 2V to 12V, offering a wide spectrum of RPM and torque. The table below provides a clear overview of the motor’s performance,...

This is the 200RPM geared motor, these motors are simple DC Motors featuring gears for the shaft for obtaining the optimal performance characteristics. They are known as Center Shaft DC Geared Motors because their shaft extends through the center of their gearbox assembly. These standard size DC gear motor are very...

The 200 RPM Single Shaft L-Shaped BO Motor delivers excellent torque and speed even at lower operating voltages, which is one of its key advantages. This motor is a low-cost geared DC motor and serves as a practical alternative to metal-gear DC motors. It operates within a voltage range of...

This 200 RPM straight single shaft BO motor provides a reliable combination of good torque and stable speed even at low operating voltages, which is one of its key advantages. The compact shaft design, along with compatible wheels, allows for an optimized and efficient setup in robotic applications. Its lightweight...

A cermet preset is a compact, PCB-mountable variable resistor with three terminals. As the preset is adjusted, the voltage between its terminals changes accordingly. Variable resistors like this are used to control voltage levels in a circuit. Typically, the two outer pins are connected to Vcc and ground (0V), while...

Capacitors are essential electronic components widely used in electrical and electronic circuits for storing and releasing electrical energy in the form of an electric field. They consist of two conductive plates separated by an insulating material known as a dielectric, which can vary depending on the application. Excellent Transient Response,...

A glass fuse is a widely used electrical safety component designed to protect circuits from damage caused by overcurrent or short circuits. It consists of a thin metal wire or filament enclosed inside a transparent cylindrical glass tube, with metal end caps on both sides for easy installation in fuse...

A cermet preset is a compact, PCB-mountable variable resistor with three terminals. As the adjustment is rotated, the voltage across its terminals changes accordingly. Variable resistors are used to adjust voltage levels in a circuit as required. Typically, the two outer terminals are connected to Vcc and ground (0V), while...

Introduction The 20MHz Crystal Oscillator is a precision electronic component used to generate a stable clock signal for microcontrollers, digital circuits, communication systems, and embedded electronics. It operates at a fixed frequency of 20 megahertz (20MHz) and provides accurate timing and synchronization required for reliable circuit operation. Crystal oscillators are...

Capacitors are essential electronic components widely used in electrical and electronic circuits for storing and releasing electrical energy in the form of an electric field. They consist of two conductive plates separated by an insulating material known as a dielectric, which can vary depending on the application. Excellent Transient Response,...